Trailer Wiring Kit YWJ500220 By Atlantic British For Land Rover LR3, Includes Flat-4 And 7-Way Connectors

Product Reviews

Posted 08-17-2023

Verified Purchase

By Marques Vestal

Fast shipping. Great quality. Easy installation. I goofed and didn't follow the directions closely, so I didn't realize I needed to remove caps on the existing LR3 harness. I knew the directions mentioned the caps, but I mistook mine as bare connectors without caps. So, completely my own fault. I did reach out for help via email, which proved a bit unhelpful and inefficient. I figured out what I was doing wrong eventually. Not really faulting AB for not answering a kinda stupid question inefficiently. They gave me everything I needed to succeed and I just failed to it. You'll find in the directions that you need to have your body control module reprogrammed. Not entirely necessary.

Posted 10-04-2022

Verified Purchase

By Henry Hawthorne

well designed kit and clear install instructions made for an easy job

Posted 06-29-2022

Verified Purchase

By Doug Leeber

Parts was has ordered and fits as advertised, the delivery time was great

Posted 04-21-2022

Verified Purchase

By Joshua Custom Rozenhart

I thought the harness was easy enough to install. Connecting it up to existing ports was literally a snap. The one port did look like it was missing a small metal terminal (there were 3, and it looked like there should have been 4). The actual female ends to receive the trailer lights were difficult to install due to limited space and an older Land Rover where the threaded openings to receive the bolts were too rusted. I had to get smaller bolts with washers and nuts (and let me tell you, that was no easy task given how small the area was) Great service from this group, and it shipped fast.

Posted 11-22-2021

Verified Purchase

By James Mangini

I found the video(s) and printed instructions to be a bit...lacking. Here's how "I" did it. First I dropped the upper harness wires (with the 2 rubber grommets) down through the opening below and let the two connecters hang below the bumper. Next, I fed the lower harness wires through the receptacle opening and behind the bumper toward the low tail light opening with fish tape. Exposing all connecters for easy access. Last and DEFINETLY not least. The 7-way receptacle. With the 4-way pointed to the center line I pushed THE LOWER HALF of the rept. in first. Then firmly pressed DOWN and IN. Top pops in. Using thin nails I lined up 3 screw holes and installed a screw. Rest, followed suit.

Posted 11-16-2021

Verified Purchase

By James Mangini

Works well as expected. Fish the lower wiring through the bumper hole towards the tail light opening FIRST. Leave a little slack to manipulate the 7 way. Note: the receptacle IS TIGHT. But it fits. Push the lower half of the receptacle in first. Then push it DOWN and IN the top half pops into place. Lastly, if you hold your mouth just right you'll get the mounting screws to bite.