Say Good-Bye to the 3 Amigos A common issue with Discovery Series II , is the shuttle valve failure on the ABS System. The failure is indicated when the warning lights come on for the ABS, ...
Views: 216,506
Step-by-step, we remove and replace the rear brake pads and rear rotors on your LR3 (2005-2009) or Range Rover Sport (2006-2009). Doug, our Land Rover Master Technician, will also explain how to ...
Views: 172,825
How to remove and replace the brake pads and caliper guide pins on a Land Rover Discovery Series, II 1999 - 2004. Watch Jim as he demonstrates how to remove and replace the brake pads and guide pins ...
Views: 95,876
A common problem for Land Rover LR3s is failure of the brake light switch. Watch Doug go over the process of accessing the brake light switch on an LR3. Procedure is the same for the Range Rover ...
Views: 94,837
Brakes are the most common repair you can perform on you Discovery 2. Watch Doug, our Land Rover Master Technician, give a demonstration of the process involved in installing new front and rear ...
Views: 67,567
Need to learn how the replacement of brake pads and rotors is done on a Range Rover Sport Supercharged? Watch Doug, our Land Rover Master Technician, explain the difference between front brakes ...
Views: 58,658
Watch Doug, our Land Rover Master Technician, show you how to bleed the brakes on a Range Rover Full Size, 2003 - 2005 (L322). Using Motive Products Power Bleeder, Part #s 9508 & 9508K with ...
Views: 50,447
Notice a loss of braking power? Do you need to pump your brake pedal to get your brakes to activate? If you've checked the brakes, looked at the slides, with everything else in the braking system ...
Views: 50,182
The Range Rover Sport or Full Size Supercharged has the 6 piston Brembo Brakes and a lot of guys get intimidated by that, where it really is not that hard to do. So what we're going to do is show ...
Views: 47,245
After 105,000 miles, your Land Rover Discovery Series 2's brake hoses have taken a beating inside and out. Watch Doug explain the process involved in installing the brake hose and brake fluid for a ...
Views: 33,443
Watch Jim as he shares some tips for installing a front ABS sensor on a Discovery Series 2. Procedure is same for all Discovery Series II vehicles from 1999 to 2004.
Views: 29,567
Outfitting a Discovery Series II for Off-Road, Part One (Extra) Now that we have added a raised suspension for off-road use, watch Doug, our Land Rover Master Technician, as he removes and replaces ...
Views: 21,130
Any ABS fault on your Land Rover Discovery Series II is going to activate the Three Amigos, which is essentially your ABS, your hill descent and your traction control lights on the dash. But you use ...
Views: 19,149
Original brake hose on your Range Rover Full-Size L322 are made of rubber which wears down and drys up so you'll want to replace at 105,000 miles. Our brake hose is made of stainless steel for ...
Views: 13,580
Watch Doug, our Land Rover Master Technician, explain the process involved in installing the brake hose and brake fluid for a 2006-2009 Range Rover Sport (both naturally-aspirated and Supercharged). ...
Views: 7,643
After 105,000 miles, your Freelander's brake hoses have taken a beating inside and out. Watch Doug, our Land Rover Master Technician, explain the process involved in installing the brake hose and ...
Views: 6,418
After 105,000 miles, your Land Rover Discovery 1's brake hoses have taken a beating inside and out. Watch Doug, our Land Rover Master Technician, explain the process involved in installing the brake ...
Views: 4,066