4 reviews 4.8 out of 5 stars
Note: Stock Land Rover ignition cable size is 7mm. Some customers have requested these higher performance 8mm wires, but be advised, they require custom fitting and do not fit the stock wire loom.
Performance Magnecor ignition wires feature superior construction, including silicone jackets and thick insulating boots for increased life during high temperature operation. Wires are exact lengths, avoiding the 'snake-bundle' look under the bonnet.
Magnecor 8mm Performance Electrosports 80 Ignition Wires improve ignition performance - period.
They provide enhanced performance as direct replacements for original equipment wires. Designed to improve original ignition system performance on stock vehicles using either electronic engine management systems or carburetors. They provide exceptional RFI and EMI suppression to permanently eliminate typical performance and fuel-wasting spark energy deterioration of OE and aftermarket carbon conductor wires. They also eliminate performance problems associated with poorly suppressed aftermarket spiral conductor wires on both modern and older engines. The conventional style insulating jacket consists of high dielectric strength silicone rubber insulation, fiberglass reinforcing braiding and a high temperature, high tear strength silicone rubber outer jacket. The flexibility and ruggedness of the cable allows it to be fitted into original 8mm cable holders. Ideal for use on heat-generating LPG (propane) gas conversion engines.
Performance Conductors: Magnecor 8mm Electrosports 80 Ignition Wires feature Magnecor's Metallic Inductance EMI Suppressed Conductors; specially-constructed to meet the exacting specs of your engine.
Click Here for detailed specifications on these Magnecor Ignition Wires.
4 reviews 4.8 out of 5 stars
Posted 01-25-2021
Verified Purchase
By William Russell
With the P38A's driver's side head off,(head gasket),it's a prime time to add fresh wires. (New coil pack's had been recently been replaced, 80,000 miles ago, as well as Iridium plugs, then also.) Anyone who has performed this "swan dive act", (over a BOSCH intake engine, while "in situ"), knows of torn knuckles? (Discovery's are even tighter)?! These particular, wires perform good/very well, with around 200 miles on them, since purchased. They also "fit" into the stock plug separators, on the valve covers. Not, "seat-of-the-pants-performance", but, solid piece of mind, with EFI suppression. These are worth the money, without going unreasonably overboard, with a stock ignition system.
Posted 05-20-2019
Verified Purchase
By david liechty
Purchased the NGK 7mm previously.. that was a mistake. Disco II running smooth so far! "Expensive" but so far worth the investment.
Posted 11-28-2018
Verified Purchase
By Kevin Prisco
The item arrived when expected and as described. The item fit just as described, it was easy to install.
Posted 03-16-2017
Verified Purchase
By Joseph Ivey
These wires have been recommended by every person that has an opinion about spark plug wires. I can see why. Worth every penny.
Read All 4 Reviews Review this itemTo ensure parts fit your vehicle, please select your rover below.