Trailer Wiring Kit for Range Rover HSE (L322) 2010-On
Applies To:
Item: VPLMT0008ABP
Fits: Range Rover HSE (L322) 2010-2012 | 2010-2012
We've specially-developed this trailer wiring package for Range Rover HSE (L322) 2010-12 vehicles. This kit seamlessly converts your Rover wiring plug to either a standard 'Flat 4' North American spec plug or 7-way plug (both connectors included!). Our quality harness kits are dependable and cost a fraction of the genuine versions. They feature a rubber plug cap to protect the exterior trailer plug from the elements and easy plug-and-go installation means they can be installed in minutes.
Parts included in Kit #VPLMT0008ABP:
- Wiring Harness
- Mounting Bracket
- Bracket Mounting Bolts
- Trailer Connector Mounting Screws
- Installation Instructions
Tools Needed for Kit #VPLMT0008ABP:
- Phillips Head Screwdriver
- 13 mm wrench (or socket)
Installation Procedure:
1. Locate the Wiring Access Opening underneath and behind the rear bumper and remove the rubber grommet. (See Figures # 1 and 2 below)
(figure 1)
(figure 2)
2. Locate the Bracket Mounting location. (See Figure # 3)
(figure 3)
3. Mount the bracket to the vehicle using the 2 ea. M8 x 1.25mm by 20mm long bolts. (See Figure #4)
(figure 4)
4. Feed the harness connector through the opening created by removing the grommet in step #1. Pull it through to the inside of the trunk well. (See Figure # 5)
(Figure 5)
5. Secure the harness grommet in the opening. (See Figure #6)
(figure 6)
6. Using the 4 ea. M5 x 0.8mm Philips Head Machine Screws secure the Trailer Connector to the bracket. (See Figure #7)
(figure 7)
7. Your Trailer Connector should look like this. (See Figure #8)
(figure 8)
8. Locate the vehicles trailer connector inside the well in the trunk. (See Figure #9)
(figure 9)
9. Plug the harness connector into the vehicles connector. Using a diagnostic computer, set the vehicle to "Trailer Capable."