Item: ABPXFA04 Fits: Range Rover 4.0 (P38) | '95 - '02 Range Rover 4.6 (P38) | '95 - '02
Hardware includes:
8 - 1/2" Button Heads
8 - 1/2" Nuts
Tools Required to Fit:
3/4" Wrench/Socket
5/16" Allen
Torque Value:
60 Ft./lbs.
Note: above tools and torque apply for kit parts only. Refer to workshop manual for tools required and torque values when removing/reinstalling suspension/chassis hardware.
Remove sway bar
Remove radius arm bolts and nuts
Inspect track rod clamps. It may be necessary to rotate them to have clamp screws pointing �up�, else there could be interference with axle guard main plate
Fit axle guard LH & RH brackets with tabs facing OUT. Replace hardware
Attach skid plate to installed brackets with supplied hardware and tighten
Check all work. Tighten all fasteners. Do not over-torque
Periodically check fasteners for tightness and integrity. This applies particularly during post 4-wheeling inspections. Wash out any accumulated debris/dirt as soon as possible
Occasionally it is recommended to wipe the surface of the guard with a light oil to help maintain appearance and to lubricate fasteners
Select Your Vehicle
