Instructions

Load Controller II

Applies To:

Item: #9264
Fits: All

Battery Manager Installation Instructions

This part of the installation should be done after the air spring kit is installed. 

If you are adding this control system to an Air Lift SuperDuty application, then no modifications to the Low Pressure Sensor are necessary. If you are adding this control system to an AirLift 1000 or RideControl application, and if your specific application requires a minimum of 10 p.s.i, then it will be necessary to adjust the Low Pressure Sensor to 10 p.s.i. To increase to pressure in the Low Pressure Sensor, remove the rubber plug with pliers (Figure 2). Using an Allen wrench, turn the screw clockwise 4-1/4 turns (Figure 3). Push rubber plug back into the top of the Low Pressure Sensor. Proceed with the step-by-step installation instructions.

Do not cut, trim, modify, or disassemble the harness. If you have excess length, simply coil it up and secure out of the way with the provided tie straps.

IMPORTANT: All preassembled gauge panels have been 100% leak & function tested. DO NOT attempt to tighten, loosen, or adjust any fittings or connections. This will likely cause a leak or malfunction and void the warranty.

1  2  3  4  5  6  7  8 

Complete Product Instructions List Page