Select Your VehicleDiscovery I Steering Skid Plate
Applies To:
Item: BA083A - w/o Brush Bar
Fits: Discovery I | '94 - '99
Range Rover Classic | '87 - '95
Item: BA083B - with Brush Bar
Fits: Discovery I | '94 - '99
Range Rover Classic | '87 - '95
Kit Includes
2-Brackets(1 left hand, 1 right hand), 1-110 x 10M Bolt, 5-M10 Nuts, 5-M10 Flat Washers, 4-30 x 10 Set Bolts
To fit steering skid plate, first remove the nuts from bottom bumper mounting bolts at the front end of the chassis. Check that the threaded ends of the bolts are pointing to the center of the vehicle.
There are two tubes welded to the chassis toward the rear of these bolts, one carrying the steering linkage.
Put the brackets in place, the slotted hole picks up on the bumper mounting bolts and the round hold on the steering bolt; on the other rear round hole picks up on the tube using the long bolt supplied. Then replace all nuts, but do not tighten them. Then put up the steering skid plate to the bracket keeping the edge with the two cut outs to the front of the vehicle and bolt to the brackets, then tighten all nuts and bolts.
1
