Shopping Cart
Instructions
A/C & Heater Blower Motor Resistor for Range Rover Classic 1990 - 1994
Applies To:
Item: PRC8010
Fits: Range Rover Classic | '90 - '94
** Section II - Removing the Dash Top for Access to the Connector (if needed):
Note: On some trucks the harness connector is secured to the main harness inside and you cannot pull the harness out far enough to unplug it. In this case, the dash fascia and dash top will need to come off to provide access to the harness, clip and the tie strap securing it to the main harness. To do this, follow the steps below. Alternatively, if you do not want to remove the dash fascia and top, you can cut the connector wires and splice the wires on to the new replacement resistor (to do this, see section III).
Dash Fascia Removal:
1. Pop out all of the louvers from the fascia. (The fascia and louvers can be seen on photo 13)
Photo 13
2. Locate the screws securing the fascia to the dash (See photos 14 and 15)
Photo 14
Photo 15
3. Remove all 13 screws (photo 16)
Photo 16
4. Unplug the connectors for the clock and mirror controls. (photos 17 and 18)
Photo 17
Photo 18
Note: Vehicles without
wood-grain fascia will also need the mirror control switches popped out.
The fascia can now be removed.
Select Model 
