Instructions

AM/FM Power Antenna

Applies To:

Item: 9124
Fits: Discovery I | '94 - '99

Mast replacement

Part number 44-PWR64 Chrome mast

  • Upgrade - 44-PWR64B Black Mast & nut
  • Upgrade - 44-PWR64G Gold Mast & nut

Remove antenna mounting nut (Diagram 4, figure A).

To remove mast, turn radio switch on to raise antenna. Remove mast, serrated plastic cable and contact spring. Save and clean contact spring for re-use.

Note which side of antenna serrated cable is facing. (Diagram4, figure B).

Insert serrated cable of new mast into the housing and stop when resistance is felt, approximately 12". The serrated side of cable must duplicate original direction.

Turn radio switch off to lower antenna until serrated cable catches. It may be necessary to cycle antenna several times (by turning radio switch on and off) until cable catches the gear mechanism and retracts. (Diagram 4, figure C).

Reinstall mast into housing and place contact spring onto mast with flanged end up. (Diagram 4, figure D).

Reinstall antenna-mounting nut and tighten.

The mast may only retract or extend halfway. Cycle several times (by turning radio switch on and off) until the mast fully extends and retracts.


1  2  3  4  Next Page

Complete Product Instructions List Page