Shopping Cart
Instructions
Range Rover 4.0 / 4.6 (1995-2002) Coil Spring Conversion Kit With EAS Override Harness
Applies To:
Item: 9520LB
Fits: Range Rover 4.0 (P38) | '95 - '02
Range Rover 4.6 (P38) | '95 - '02
Section 2 Continued
Photo 20
Using a suitable tool (we used two hack saw blades) slide a thin blade type tool along the top and bottom to push the locks in and slide the switch out. (photo 21) Once the switch is out unplug the connector from the rear and leave off. Replace the switch to the original position.
Photo 21
5. It is not necessary to do anything to the inhibit switch.
Section 3
This section will address the electronics under the hood.
1. On the passenger side locate the fuse/relay box and remove the cover. Locate and remove relay RL20. It is the third from the left as you stand by the right fender. (photo 22) It is yellow and right next to the maxi fuses. RL20 will be stamped in the fuse box underneath the relay. Save this relay as it has multiple applications on the car. Replace the cover.
Photo 22
2. On the drivers side locate the compressor box and remove the cover.
Find and unplug the compressor. The connector has four wires in it. (photo
23) Replace the cover.
3. Reconnect the battery. Recode the radio. You will also have to reset
the windows and sunroof. To do this start with the window closed. Run the
window all the way down then up fully. Hold in up position momentarily. The
message board should say window "set." Repeat with all the windows
and sunroof. This will restore the one touch feature. Also you will need to
resynchronize the key remote. Do this by locking the car with the key and
push the lock button. Unlock the car with the key and push the unlock button.
This should restore the remote function.
Select Model 
