Shopping Cart
Instructions
Range Rover 4.0 / 4.6 (1995-2002) Coil Spring Conversion Kit With EAS Override Harness
Applies To:
Item: 9520LB
Fits: Range Rover 4.0 (P38) | '95 - '02
Range Rover 4.6 (P38) | '95 - '02
Section 1 Continued
Front Spring Installation:
1. Install the new front spring isolator (ABP# RBC100111G)
using the four existing holes (photo 5) where the upper pins for the air springs
were. Secure with four lock nuts (ABP# 1014).
Photo 5
Reach in from the top and pull the excess rubber up thru the hole. (photo 6) This will ease the installation of the front spring.
Photo 6
2. Assemble the front coil spring assembly outside the car. It is easier to tighten the retainers and there is plenty of room to install the springs as an assembly. Assemble as follows: install seat (ABP# NRC9700G) onto adaptor (ABP# 8006) place spring on seat (note front spring has white stripe) and secure with retainer (ABP# NTC6106) and two nuts (ABP# 1019). (photo 7)
Photo 7
3. Install the spring assembly and rotate until the adapter lines up
in hole of spring perch. You can install the saved retainer clip now or wait
until the suspension is compressed.
4. Repeat for opposite side.
Select Model 
