Print This Page

Instructions

Range Rover 4.0 / 4.6 (1995-2002) Coil Spring Conversion Kit With EAS Override Harness

Applies To:

Item: 9520LB
Fits: Range Rover 4.0 (P38) | '95 - '02
Range Rover 4.6 (P38) | '95 - '02

 

Section 1 Continued

7. Remove the ride height sensors front and rear. Access to the connector for the Rear sensors is over the rear trailing arms. Access for the connectors at the Front sensors is behind the plastic fender wells. Remove as many plastic rivets as necessary to pull the plastic fender well aside to access the plug for the sensor. 

 


Photo 3

 

Pull the center of the rivet out (photo 3) using pliers or suitable tool and then remove the rivet.
Use the provided wire tie to secure the wiring at the removed sensors front and rear. Reinstall the fender well and secure with original rivets. Trucks from 1997 and newer: It is not necessary to remove the wheel well to access the connectors for the height sensors. The harness plugs directly to the sensor.
8. If you are replacing the shocks remove them at this time.

 


Photo 4


9. Remove the bump stops and replace them with the polyurethane bump stops (ABP#8010) (photo 4) you may need to lubricate the stops with WD40 or equivalent to ease installation. These stops allow 1-1/2 inches more suspension travel. 
10. If installing new shocks put them in now attaching at the top only.

 

 

 1 2 3 4 5 6 7 8 9 10 Next Page

Complete Product Instructions List Page